Hi,
I would like to know if I can enter in the intraday trade exactly at 09:15am? After meeting certain conditions.
yes… but better chance when you bid during pre-open session.
Let me know if this is possible using streak not manually.
try below, else @Streak might have some solution
You can simply use the Candle time function to create the conditions to enter at any specific time of the day. You can refer to the below conditions to enter the trade at 09:16-
[image]
You can also simply create the condition “Close(0) higher than 0” and select the Entry start time as needed and select the base time frame as 1 minute to get the entry at the selected Entry start time and also get a re-entry after the exit from the trade.
Additionally, you can use the Dynamic contract functio…
Hi,
The message says I have to select 1 min timeframe and then I can enter at 09:16 whereas I want to enter at 09:15 itself.
At least this is what I was able to interprete, correct me if I am wrong.
Yes, you can, but by using a bot, not possible manually
Streak
November 8, 2024, 6:00am
7
Hi @J_Mandar
Kindly note that Streak works on OHLC data that is available after the closing of the candle.
Hence entering directly after the market opens at 9:15 am cannot be implemented.
You can refer to the link below to enter the trade after the closing of the 1-minute candle at 9:16 am as a workaround.
You can simply use the Candle time function to create the conditions to enter at any specific time of the day. You can refer to the below conditions to enter the trade at 09:16-
[image]
You can also simply create the condition “Close(0) higher than 0” and select the Entry start time as needed and select the base time frame as 1 minute to get the entry at the selected Entry start time and also get a re-entry after the exit from the trade.
Additionally, you can use the Dynamic contract functio…
Hope this clarifies the doubt.
So regardless of any entry conditions, it is impossible to enter the trade 09:15am right?
Streak
November 10, 2024, 3:32am
9
@J_Mandar
Unfortunately, this requirement cannot be implemented within the Streak platform.